The other day I was checking the fluid
levels on my car and noticed the coolant level was very low. It was
supposed to be filled up to a certain line about half way, but it was
all the way at the bottom. So I got the recommended coolant to
proceeded to fill it back up.
On some cars like mine, it can be hard
to see the fluid level from the side and I ended up putting too much
coolant in which brought the level to about 1 inch over what is was
supposed to be. After doing some research, it looked like it would
not be a huge problem, but I still wanted to get it back down to the
recommended level.
I started thinking of possible
solutions to fix this problem. The first thought was to use something
like a turkey baster to put in and draw out the excess fluid. Only
problem is I did not have a turkey baster available.
Next I thought about using a straw by
dipping the end of it into the coolant, closing the top of the straw
and pulling out the liquid little by little. This method might work
but would probably take a while. Also, in my case, I did not have any
straws available at the time.
I figured I might have to go to the
store to get one of the above items, but just in case, I kept looking
around the house for any tools that might get the job done. Then I
found it! A spray bottle such as glass cleaner would do the trick!
Here is how to use the top of a spray
bottle to remove excess coolant from the car in case it has been
overfilled:
First, unscrew the spray part of the
bottle and put the bottle aside. Next, spray out the extra liquid in
case the straw still has some left over from the original bottle. I
also recommend putting the end in water and spraying it a few times
to make sure it is cleaned out. Once it is empty and dry, take the
spray part and an empty bottle to the car.
Make sure the car is off and the engine
is cold. Slowly unscrew the cap for the coolant reservoir and set it
aside. Next, take the spray and dip the end of the straw down into
the coolant. Take the empty bottle and position it so you will be
able to spray the coolant into the bottle. Then start spraying!
It can go pretty quick, but it may take
many sprays to get it to the level you want it. I found it took about
60 sprays to drop the level down about 1 inch. Check it every so
often so you will be ready to stop when it reaches the correct level.
Once it is at the right level, take the hose out and screw the cap
back on.
You can save the extra coolant for
later in case it gets low again at a later time. I hope this helps!
Disclaimer: I am not a mechanic,
but I found this to be a good solution to the overfilled coolant
problem by using household items most people may have around the
house.